- ONLINE SPECIAL
- - 37 %
DRONE RACER LapCounterBasicSet(Shop ed.) 32031
Basic Set of the lap counting system for holding DRONE RACER racing events
Infrared LED installed in the DRONE RACER cockpit lights up to indicate the special DRONE RACER lap counter system is measuring the number of laps and lap times. This ‘Basic Set’ incorporates special software allowing up to 6 models to be raced together and is also able to be connected to RC Timing’s RCM (Race Control Management) system used at major RC race events. Simply connect via your PC to use this precision lap counting system to take your DRONE RACER experience to the next level. Increase excitement with even more light and sound by adding the Signal Set, Gate LED Set, and Floor LED Set to create a futuristic racing scene.
Create a futuristic racing experience with light and sound by adding the Signal Set, Gate LED Set and Floor LED Set.
Basic Set connection diagram. Gate LED Set features 5 infrared sensors installed at 50cm intervals for a maximum width of 2.5 meters. For an even wider gate, up to 16 infrared sensors (No.32035, sold separately) can be added. Infrared sensors can be attached to a bar using cable ties.
Diagram of Lap Count System at maximum configuration with Signal Set, Gate LED Set, and Floor LED Set x 2 connected. Each set is connected via LAN cable and can be connected in any sequence.
Screen shot of included timing measurement software. Up to 6 models can be measured simultaneously. (Screen shot shows 9 models but the software can only be used with a maximum of 6 models). A computer with an Internet connection to download the timing measurement software must have the following minimum system requirements: Windows 7/8/8.1/10, 32/64 bit, available USB port.
USB cable (1m)
Sensor unit (5)
LAN cable 10m (1)
LAN cable 50cm (4)
Requirement to Run
<Required for Operation>
Computer (Windows 7/8/8.1/10, 32/64bit, with available USB port)